T-tech TT100 User Manual download pdf (Page 22)

Dodge Dakota (to 1997) and some Ram

FIT403

Note: Whenever using special fittings from FIT403, start them

by hand and slowly tighten enough to prevent leaks.

Use FIT403 on the 1995 to 1997 Dakota (see FIT412 for post

1997) and some Ram models.

The quick connect fitting in the Dodge Dakota transmission

cooling line (at the radiator) requires a removal tool that is not

supplied. FIT403 is installed on the Dakota as illustrated in

Figure 54.

CAUTION: These fittings are a matched set and must be kept

together in the small plastic box marked FIT403.

Instructions

1. Remove the transmission cooling line with the line

removal tool.

2. Insert the small fitting into the receptacle and continue

pushing until the plastic clip in the receptacle engages

the fitting.

3. Install a service adapter hose on the small fitting and

another on the vehicle transmission cooling line.

Clamp both in place and start service.

Dodge Ram

[Pre-2004 Assorted Gasoline engines only]

CAUTION: It is VERY easy to damage the radiator threads on these vehicles. The radiator fittings on assorted 1995-

2004 DODGE RAM TRUCKS are brass and the threads are 9/16-24 ultra fine cut. The threads can be stripped as

the technician removes the line. We recommend that you access the line either at the transmission or at the hose

clamp connection (if available). If you decide to remove the radiator fitting, use the following steps to help eliminate

damaging the fitting. Careful handling of the vehicle is the responsibility of the technician.

T-TECH will not accept

any liability for vehicle damage.

1. Spray the fitting with penetrating oil.

2. Break the nut loose with a wrench.

3. Finish removing by hand only.

4. Replace the nut by hand only.

Note: Whenever using special fittings from FIT403

start them by hand and only tighten enough to

prevent leaks.

The quick connect fitting in the Dodge Ram transmission

cooling line (at the radiator) requires a removal tool that is not

supplied. The FIT403 male fitting goes on the end of the steel

line and the female fitting goes on the radiator (see Figure 55).

CAUTION: These fittings are a matched set and must be kept

together in the small plastic box marked FIT403.

Instructions

1. Remove the transmission cooling line with the line removal tool.

2. Insert the small FIT403 fitting into the receptacle and continue pushing until the plastic clip in the

receptacle engages the fitting (see Figure 55).

3. Insert the large FIT403 fitting onto the transmission cooling line (see Figure 55).

4. Install a service adapter hose on each fitting. Clamp both in place and start service.

Line

Removal

Too l

From FIT403

Push into the receptacle

until the plastic clip

engages the fitting

Vehicle Transmission

Cooling Line

Attach Service

Adapter Hose

Attach Service

Adapter Hose

Vehicle Transmission

Cooling Line

Radiator

Figure 54. FIT403 Installation on Dodge Dakota

Vehicle In-Line

Transmission

Tubing

Radiator

From FIT403

Figure 55. FIT403 Installation on some Dodge Ram

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 37 38

Comments to this Manuals

No comments

T-tech TT100 User Manual Page 22

Comments to this Manuals