T-tech TT100 User Manual download pdf (Page 14)

Fill Cylinder Function

The Fill Cylinder function is used to fill the T-TECH cylinder with new ATF and empty the cylinder of old ATF.

CAUTION: Fill cylinder completely. Air below the piston will result in an incomplete exchange as this air will

compress and not move the piston at beginning of the exchange process. (This condition usually occurs only during

the initial fill.)

Using a Bulk Dispenser Gun

To use this method, a bulk dispenser gun (see Figure 38) accessory kit must be used. The accessory kit is an

optional kit not supplied with the T-TECH. The bulk dispenser gun accessory kit must be ordered separately (Part

No. FIT200, see Replacement Parts List).

CAUTION: Ensure that your air delivery system does not exceed

75 psi at the point of delivery. Many air systems have a 3:1 or 4:1

pressure ratio – this means you must dial your system down to

compensate for the output delivery ratio. Monitor the gauge on

the T-TECH control panel to ensure that 75 psi is not exceeded.

CAUTION: Fill cylinder completely. Air below the piston will result in

an incomplete exchange as this air will compress and not move the

piston at beginning of the exchange process. If this is the first time

your

T-TECH machine has been filled, there will be air under the

piston instead of old ATF. The air must be allowed to exit just

as if it were old fluid. See Note on Step 3 below.

1. Determine ATF type needed for your next service.

2. Set CONTROL VALVE (on control panel on the side of the unit) to FILL CYLINDER.

3. Attach a service hose adapter to the end of each service transfer hose.

Note: Although the used fluid will exit only one service hose when filling the cylinder with new fluid,

it is critical that you connect service hose adapters to both service transfer hoses every time

you fill the T-TECH.

4. Insert both service hoses into a container suitable for collecting and disposing of old ATF. The container

must be capable of holding a minimum of 18 quarts (the full capacity of the

T-TECH cylinder).

Note: Always follow your local environmental protection agency guidelines for proper disposal

of ATF.

5. Using the proper fittings that correspond to

your dispenser gun, connect the bulk dispenser

gun to the CYLINDER FILLING port on the

control panel on the side of the

T-TECH

(see Figure 38) .

6. Press the trigger on the bulk dispenser gun.

The flow direction for filling new fluid from a

bulk dispenser gun is shown in Figure 39.

7. Verify that the pressure gauge on the

T-TECH

control panel does not exceed a reading of

75 lbs.

8. New fluid should begin flowing into the top of

the cylinder. An equal amount of used ATF is

being displaced and forced out of the

T-TECH

through one of the service hoses and into your

designated used-ATF disposal container.

9. Continue the process until the cylinder is filled

with the required amount of new ATF.

Overflow

Tank

Bulk Fill

Service

Port

Hoses

To and From

The

Transmission

Automatic

Bypass

Line

Automatic

Alignment

Valve

Check

Valve

Three

Way

Valve

FILL

Position

Check

Valve

Check

Valve

Check

Valve

Old

Dirty

Fluid

New

Fluid

Pressure

Relief

Valve

System

Pressure

Figure 39. Flow Direction From A Bulk Dispenser Gun

Bulk

Dispenser Gun

Nipple

Female Coupler

Connects to Male

Coupler on T-Tech

Male

Coupler

T-TECH

Control

Panel

Figure 38. Bulk Dispenser Gun Connection

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Comments to this Manuals

No comments

T-tech TT100 User Manual Page 14

Comments to this Manuals