T-tech TT100 User Manual download pdf (Page 30)

Toyota

Toyota Camry

Note: When servicing Toyota Camry’s with 4 cylinder engine, a low line pressure condition may be encountered.

This is normal and requires the following steps to perform the service.

1. With the T-TECH connected to the vehicle through a cooler line, start the vehicle.

2. Set the parking brake, with one foot on brake, place the transmission in neutral and increase the engine

speed to 1900 RPM. Monitor the exchange process until completed.

3. If the transmission is still not producing the needed pressure for an exchange, increase the engine speed

to 2300 RPM. Monitor the exchange process until completed.

4. If the line pressure is still too low to perform a service, stop the exchange and disconnect the

T-TECH. The

vehicle may have other problems that need to be corrected before service can be completed.

Volkswagen

A fluid exchange service cannot be performed on most Volkswagen automobiles, including Jetta, Golf, Passat and Audi.

CAUTION: These vehicles do not have automatic transmission fluid cooler lines. In some cases, Volkswagen

transmission lines may have radiator coolant in them. This is because the heat exchanger is located inside the

transaxle.

Volvo 850 FIT409

The Volvo 850 uses a fitting that requires special parts to complete a T-TECH service.

CAUTION: Some of these fittings are a matched set and must be kept together in the small plastic box marked

FIT409.

Instructions

1. With an expansion pliers (a common screwdriver, 1/2 inch

wide will also work), expand the clip and remove the line

and clip from the radiator.

2. Remove the clip from the line.

3. Install a lathe cut ring and an o-ring on the fitting.

4. Install the clip on the FIT409 fitting.

5. Push the fitting and clip into the radiator. The ramps will

automatically expand the receptacle on the radiator.

6. Push a service adapter hose over the fitting and clamp

down.

7. Push fitting FIT321 over the transmission cooling line and

clamp it in place.

8. Attach a service adapter hose to FIT321.

9. When service is complete, return the special fittings to

FIT409 (Figure 64) case and FIT321 to the assigned

location in the fittings drawer.

O-Ring

Lathe Cut Ring

Transmission Cooling

Line Attached to

Radiator

FIT409 Special

Fitting

Radiator

Clip

Radiator

Standard Fitting

FIT321

Sevice Adapter

Hose

Transmission Cooling

Line

Figure 64. FIT409 Installation On Volvo 850

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Comments to this Manuals

No comments

T-tech TT100 User Manual Page 30

Comments to this Manuals